ParaPlast Care Wall Putty

Paraplast Care Wall Putty is white cement based wall putty added with essential chemicals. It is ideal for cement plastered interior/exterior walls & ceilings. It can also be used for leveling/filling the uneven surfaces of cement plastered walls and concrete walls. Paraplast Care Wall Putty gives smooth and strong surface to the walls for further application of all kinds of paints and gives better look to interior & exterior walls.

  • Whitest Putty
  • Highly water resistant
  • Strong bonding to the base plaster
  • Smooth finish
  • Excellent workability
  • UV Resistance
  • True colour tone of the paint is maintained, primer is not required
  • Protects expensive paint from dampness, peeling off and flaking.
  • Makes paint durable & long life .
  • Paint finish is superior.
  • Suitable for interior and  exterior.
  • Reduces paint consumption.
  • Avoid frequent repainting.
  • Cost – effective.
  • Aesthetic look for ceilings, interior and external walls.
  • Ease of use at site

It may used in commercial projects

APPLICATION PROCEDURE

SURFACE PREPARATION

Clean loose particles, dirt, grease and traces of foreign material from the surface, if necessary, by using sand paper or by chipping. For loose plaster areas, remove the defective material and re-plaster the area with Paramount shine  Ready-Mix Plaster. For ceilings/walls, which are not even, re-plaster it with Paramount shine  Ready-Mix Plaster.

MIXING

Take 300 – 400 ml of clean water for 1 Kg of Paramount shine  Wall Putty in a clean bucket. It is very important that Paramount shine  Wall Putty to be added in water and not vice versa. Stir continuously by using an electric mixer or by hand to obtain a homogeneous lump-free paste. Allow the resultant paste to stand for about 10 minutes for the additives to dissolve. Re-mix again for about 2 minutes. The mixture is now ready. Use the mix within 30 minutes.

APPLICATIONS

Dampen the surface to be plastered with clean water. Allow excess water to drain off. Using a steel trowel/blade, apply the above mix to a thickness of about 0.5 – 1 mm. Level and smoothen the surface. Cure the first coat lightly after it dries. Apply the second coat of 0.5 – 1 mm after the first coat has fully dried and set. In areas of high temperature and low humidity light curing for two days is recommended. The thickness of each coat should not exceed 1 mm and total plaster thickness should not exceed 2 mm. Smoother with a steel trowel, Sand paper if so desired with 600 no. of sand paper.

PRECAUTIONS

Paramount shine  Wall Putty contains only eco-friendly fillers and additives. However, being white cement based, it is alkaline and hence it is advisable to avoid direct eye and skin contact with this. In case of eye contact, flush with clean water at least for 15 minutes and seek medical help and recommended to keep it out of children reach.

SPECIFICATIONS

TECHNICAL SPECIFICATIONS

PROPERTY TYPICAL
Color White
Pot Life >90Min
PH 9.2 – 10.1
Coverage 8 – 15 Sq. ft/kg (Depending on finish of the Wall)
Recommended Mixing 300 – 450 ml of water for per kg of Paramount shine  Wall Putty